Accessories

For using together with GliderThrow, wing incidence tool is a helpful tool to measure the incidence angle between the wing and the horizontal stabilizer.

The use is simple, first block your plane in horizontal position, then put the incidence tool both in the wing and h. stab. You can lock the tool position tighten the screws in both sides.

 

Once in position reset GlideThrow both sensors in the same horizontal surface and then put it in the center tool support. Remember to put the hinge position of the sensors to the plane´s nose. The magnetic side will help to keep it in position.

 

Now in the GliderThrow page you can verify the incidence in the "Differential" frame. The relative measures of each sensor are not relevant in this case.